Advanced Hardware Engineer – EMI/EMC Design and Assurance
Job Expectations :
·Accountable and owner of technical decisions for Aerospace products EMI/EMC Design and qualification as per applicable standards
·Responsible for Architecture, High level and Detailed Design to meet the EMI/C requirements as per product standards
·Evaluate and suggest suitable grounding scheme, Enclosure design, shielding design to meet the stringent Aerospace EMI/C Requirements.
·Work as interface between HTS and Honeywell Technology Chief Engineers/Fellows/Subject Matters Expert and influence technical decisions.
·Analyze and identify the root cause(s) of the problems and provide most effective solution for complex problems working with cross functionals teams.
·Make significant technical contributions essential to the successful completion of projects
·Take care of minimum project management practices which helps to drive project scope, cost, risks and schedule to required level
Skills Requirement :
·Expertise in EMI/EMC Design, Simulation, Analysis and Qualification tests to meet highest Design Assurance levels (DAL) as per DO-160/MIL-461 standards and any other applicable standards.
·In depth knowledge of RTCA DO-160 and MIL-461 standards and involved in successful completion of Qual tests for at-least 1 project.
·Experience in a range of technologies with hands-on expertise in digital, analog, mixed signal, RF design and power electronics design
·Excellent hardware troubleshooting skills, Review PCB design of analog and digital systems for new product development
·Good understanding of Grounding and Shielding techniques. Chassis design for good EMC design is most.
·Thorough knowledge of board design, EMI Filter design, Lightning Analysis, Component selection.
·Simulation/modeling using Ansys, LT-SPICE/PSPICE is required.
·Simulation/modeling using MATLAB & SABER is an advantage.
·Mentor Schematic and Layout tools – DxDesigner, HyperLynx DRC, HyperLynx SI.
·Liaise / negotiate with the customers’/partner representatives, such as, site co-coordinators, Quality representative, engineers, consultant on the technical aspect of the job and its progress
Basic Candidate Qualifications:
·BE/BTech/MTech in Electronics & Communication or Electrical Engineering or equivalent
·Minimum of 10+ Years of overall end to end hands on design experience and expertise in Aerospace/Avionics products development
Preferred Candidate Qualifications:
·Demonstrated experience in progressively challenging and responsible roles
·Excellent focus on execution, should ensure responsiveness to customers, team and management.